Installation guide

Network Adapter Card Installation Guide
97
The ATMUX driver is now shown in the Local Area Connection
Properties window.
9. Select Allied Telesyn Multi-Vlan Support Protocol then select
Properties.
Then window shown in Figure 78 is displayed.
Figure 78 VLAN Setup Window
10. The default VLAN ID is 0. To change the VLAN ID, select Set ID.
The window shown inFigure 79 is displayed.
Figure 79 Set VLAN ID Window
11. Select or enter the correct VLAN ID. This VLAN ID is determined by
the system administrator; please contact the administrator for the
correct VLAN information. For this example, we will set the VLAN ID
to 1 then select OK.