Installation guide

Network Adapter Card Installation Guide
115
Configuration - Specifies connection options, for example, speed
and duplex mode of the card or to enable or disable Boot ROM.
Diagnostics - The Card Test verifies that your computer and the
adapter card can communicate. To run a Card Test, refer to Card Test
Diagnostics on page 115.
View Information File - Refers you to the documentation on the
CardAssistant CD.
Card Test
Diagnostics
To run a card test diagnostics, perform the following procedure:
1. From the Main Menu, select Diagnostics.
The screen shown in Figure 97 is displayed.
Figure 97 Diagnostics Menu
2. Select Card test.
3. Press <Enter>.
4. A screen is displayed, showing the Card Tests results for the
following:
EEPROM - checks that the EEPROM was read and certain values are
valid.
Loopback - checks whether a packet can be sent from memory to
the adapter card and back to memory successfully.
Line - checks for a valid connection between the adapter card and
the remote Ethernet hub or switch.