Installation guide

Product Description
Page 9
AT-8000S/24 Front Panel
The following figure illustrates the AT-8000S/24 front panel.
Figure 3: AT-8000S/24 Front Panel
The AT-8000S/24 front panel is configured as follows:
• 24 10/100Mbps ports — RJ-45 ports designated as 10/100Base-T. The RJ-45 ports are designated as ports
Ports1-24.
• 2 1000Base-T Copper ports — Copper RJ-45 Gigabit ports designated on the device as ports 25 and 26.
These are Combo ports linked to the two SFP ports.
• 2 SFP Ports — There are two SFP ports, which contain 1000Base-X (fiber) connections designated on the
device as ports 25 and 26. These are Combo ports linked to the two 1000Base-T Copper ports.
• DB-9 Console port — An asynchronous serial console port supporting the RS-232 electrical specification.
The port is used to connect the device to the console managing the device.
• Reset Button — Button to reset the device.
• Mode Button — Selects the port LED indications.
AT-8000S/24 Back Panel
The following figure illustrates the AT-8000S/24 back panel.
Figure 4: AT-8000S/24 Back Panel
The AT-8000S/24 back panel is configured as follows:
• Power Connector — AC power supply interface.
• 2 Stacking Ports — Two RJ-45 ports device stacking.