User Manual

Physical and Layer 2 Interfaces 85
Software Release 2.6.1
C613-02021-00 REV D
Default Setup
The standard LAPD configurations are shown in Table 9 on page 85 (Basic Rate
Interfaces) and Table 10 on page 85 (Primary Rate Interfaces). These settings
suit many situations. However, you can modify these settings as required to
suit other network situations (see the Integrated Services Digital Network (ISDN)
chapter, AR400 Series Router Software Reference).
Testing the BRI or PRI PIC
To test the ISDN PRI, BRI (U), or BRI (S/T) PIC you need to configure a routing
protocol such as IP or IPX to use ISDN.
For more information about configuring ISDN calls and routing protocols, see
“Configuring ISDN (AR410 only)” on page 86, “Configuring an IP Network” on
page 95, and “Configuring a Novell IPX Network” on page 107.
Table 9: Standard LAPD configuration for an ISDN Basic Rate Interface.
Mode Auto
Debug Off
TEI Provided by the network
T, N and k values (for each SAPI):
SAPI Layer 3 T200 T201 T202 T203 N200 N201 N202 k
0 Q.931 Call Control 10 10 20 100 3 260 3 1
1 Q.931 Packet Mode 10 10 20 100 3 260 3 3
16 X.25 Packet Mode 10 10 20 100 3 1024 3 3
63 LAPD Management 10 10 20 100 3 260 3 1
Table 10: Standard LAPD configuration for an ISDN Primary Rate Interface.
Mode nonAuto
Debug Off
TEI 0
T, N and k values (for each SAPI):
SAPI Layer 3 T200 T201 T202 T203 N200 N201 N202 k
0 Q.931 Call Control 10 N/A N/A 100 3 260 N/A 7
1 Q.931 Packet Mode 10 N/A N/A 100 3 260 N/A 7
16 X.25 Packet Mode 10 N/A N/A 100 3 1024 N/A 7
63 LAPD Management 10 N/A N/A 100 3 260 N/A 7