User's Manual

AT-AP500 Wireless Access Point Installation Guide
31
4. Fasten the access point to the base plate by turning the base-plate
captive screw clockwise using a Phillips-head screwdriver, as shown in
Figure 9 on page 30.
Cabling the
Access Point
To install cabling on the access point, perform the following:
1. Connect a network cable to the LAN port (labeled WAN/PoE) on the
rear panel of the access point. Refer to Figure 10. The specifications of
the cable are listed in Table 2 on page 20.
Figure 10. Connecting the Network Cable
2. If you have not already done so, connect the other end of the network
cable to a port on an Ethernet switch.
3. Do one of the following:
 If the access point is to be powered with the AT-TQ0091 AC/DC
Power Adapter, continue with this procedure to attach the power
adapter.
 If the access point is to be powered with the PoE feature on the
LAN Port, the installation procedure is complete. Go to “Kensington
Lock” on page 34 or “Starting the Initial Management Session on
the Access Point” on page 35.
4. Connect the DC power cable from the AT-TQ0091 AC/DC Power
Adapter to the DC 12V connector on the rear panel of the access
point. Refer to Figure 11 on page 32.
Review Draft 2-1-16