User's Manual

AT-AP500 Wireless Access Point Installation Guide
29
Attaching the
Mounting
Bracket to the
Access Point
To attach the mounting bracket to the access point, perform the following:
1. Place the access point upside down on a flat surface.
2. Place the bracket against the bottom of the access point and use the
bracket to push downward on the stopper nub (see Figure 6).
Figure 6. Bottom of Access Point
3. Turn the bracket in the direction of the arrows shown in Figure 7 until
the two hooks hold the bracket: The stopper nub pops up, and the
bracket locks in place.
Figure 7. Locking Bracket to Access Point
4. Attach the mounting-bracket screw through the notch in the mounting
bracket to the access point, as shown in Figure 8 on page 30: The
bracket is fastened to the access point.
Review Draft 2-1-16