System information

C613-10501-01-REV B Software Release Note AlliedWare Plus Version 5.3.4-0.1 9
100 LAG License (x600 only)
channel-group
mode
Command Modified Y N Link
Aggregation
Commands
With this command you add a switch port to a
dynamic channel group specified by the channel
group number. You can now create 32 channel
groups with a base license, consisting of a
combination of static and dynamic channel
groups.
With a feature license you can create up to 100
channel groups, consisting of up to 32 dynamic
channel groups and up to 96 static channel
groups to total up to 100 static channel groups
and dynamic channel groups combined.
static-channel-
group
Command Modified Y N Link
Aggregation
Commands
With this command you can create a static
channel group, or add a member port to an
already existing static channel group. You can
now create 32 channel groups with a base
license, consisting of a combination of static and
dynamic channel groups.
With a feature license you can create up to 100
channel groups, consisting of up to 96 static
channel groups and up to of 32 dynamic
channel groups to total up to 100 static channel
groups and dynamic channel groups combined.
ARP Logging
ARP Logging Feature New Y Y Internet
Protocol (IP)
Addressing
and Protocols
You can enable your device to log static and
dynamic ARP entries, and you can select either
default hexadecimal notation
(HHHH.HHHH.HHHH) or standard IEEEE
format hexadecimal notation (HH-HH-HH-
HH-HH-HH) for the MAC addresses displayed
in the ARP log output.
arp log Command New Y Y IP Addressing
and Protocol
Commands
This command enables and disables the logging
of dynamic and static ARP entries in the ARP
cache. This command can display the MAC
addresses in the ARP log either using the
default hexadecimal notation
(HHHH.HHHH.HHHH), or using the standard
IEEE format notation (HH-HH-HH-HH-HH-
HH).
RIP
cisco-metric-
behavior (RIP)
Command New Y Y RIP
Commands
Use this command to enable or disable the RIP
routing metric update to conform to Cisco’s
implementation. The Cisco implementation sets
the metric of redistributed connected and static
RIP routes to 0 by default. AlliedWare Plus sets
this metric to 1 by default when using the
default-metric command.
Table 2: New and modified features and commands
Feature/
Command/
MIB
Ty p e Status
x600
x908/x900
Software
Reference
Chapter
Description