System information

8 Software Release Note AlliedWare Plus Version 5.3.4-0.1 C613-10501-01-REV B
debug platform
packet
Command Modified Y Y Switching
Commands
The sflow parameter option has been added to
the debug platform packet command to display
only sFlow packets when enabled. The vlan
parameter option has also been added to the
debug platform packet command to limit
debug to a single VLAN ID specified when
enabled.
platform
enhancedmode
Command Modified N Y Switching
Commands
This command rearranges memory in the
silicon so that it can store a greater than usual
number of QoS traffic class counters, QoS
Policers, or nexthop routes. For the enhanced
mode to take effect, you must restart the
device after entering this command. The
qospolicers parameter has been added.
platform
portstorm
Command Modified N Y Switching
Commands
This command performs a port storm on the
system. This test generates a high packet load
on switch ports, exercising the packet data path
and front-panel ports.
platform prbs Command Modified N Y Switching
Commands
This command performs a PRBS (Pseudo-
Random Bit Stream) test on the switch.You can
now specify whether to test either the internal
fabric links or the stacking fabric links (x908
only), or both.
platform
routingratio
Command Modified N Y Switching
Commands
This command changes the amount of memory
allocated to IPv4 routing tables relative to IPv6
routing tables. The default routing memory
ratio is now set to ipv4andipv6 allowing both
IPv4 and IPv6 to run concurrently.
platform vlan-
stacking-tpid
Command Modified Y Y Switching
Commands
The no platform vlan-stacking-tpid command
has been added to revert to the default TPID
(Tag Protocol Identifier) value of 0x8100.
show debugging
loopprot
Command New Y Y Switching
Commands
This command shows Loop Protection
debugging information.
show debugging
platform packet
Command New Y Y Switching
Commands
This command shows platform to CPU level
packet debugging information.
show platform full
debug
Command New Y Y Switching
Commands
This command displays low-level system
information and diagnostics.
show platform
portstorm
Command Modified N Y Switching
Commands
This command displays the result of a
previously run port storm test on the switch.
Provisioning
show provisioning
(xem-bay)
Command New N Y Switching
Commands
This command shows the provisioning status of
all installed or provisioned hardware.
switch bay
provision
Command New N Y Switching
Commands
This command enables you to pre configure a
specific empty bay within a switch ready for
inserting a particular XEM type. To run this
command, the bay position must be vacant and
the selected XEM type must be one that is
currently supported.
Table 2: New and modified features and commands
Feature/
Command/
MIB
Ty p e Status
x600
x908/x900
Software
Reference
Chapter
Description