System information

C613-10501-01-REV B Software Release Note AlliedWare Plus Version 5.3.4-0.1 7
Diagnostic Monitoring (Backgroup PCS Ping)
diagnostic
monitor pcsping
Command New N Y System
Configuration
and
Monitoring
Commands
Use this command to disable or configure the
background PCS (Physical Coding Sublayer)
ping monitoring feature to either output a log
message or to power off a XEM when a
background PCS ping check fails. The
background PCS ping feature is enabled by
default to output log messages.
show diagnostic
monitor pcsping
Command New N Y System
Configuration
and
Monitoring
Commands
Use this command show the status of the
background PCS (Physical Coding Sublayer)
ping feature used to the check the link status
between a XEM and the switch.
Miscellaneous Feature Updates
show debugging Command New Y Y System
Configuration
and
Monitoring
Commands
This command displays information for all
debugging options.
speed (async) Command New Y Y System
Configuration
and
Monitoring
Commands
This command changes the console speed from
the switch.
log-rate-limit nsm Command New Y Y Logging
Commands
This command limits the number of log
messages generated by the switch. The log rate
limiting feature resolves the issue of the switch
memory becoming overloaded, which may
cause the switch to shutdown, when a packet
storm occurs, because of a network loop
generating too many log messages too
frequently for memory.
mru Command Modified Y N Interface
Commands
The MRU (Maximum Receive Unit) size can be
set using this command for a switch port (MTU
can only be set on a VLAN interface). The
negated form of this command restores the
default MRU size of 1500 bytes for a switch
port.
mtu Command Modified Y Y Interface
Commands
The MTU (Maximum Transmission Unit) size
for VLANs specified by this command has
changed from <64-9208> bytes to <68-1500>
bytes. The negated form of this command will
restore the default MTU size of 1500 bytes for
VLANs.
show interface
brief
Command Modified Y Y Interface
Commands
This command displays brief interface,
configuration, and status information, including
provisioning information.
debug loopprot Command New Y Y Switching
Commands
This command enables Loop Protection
debugging.
Table 2: New and modified features and commands
Feature/
Command/
MIB
Ty p e Status
x600
x908/x900
Software
Reference
Chapter
Description