System information

22 Software Release Note AlliedWare Plus Version 5.3.4-0.1 C613-10501-01-REV B
show provisioning
(stack-member)
Command New Y Y Stacking
Commands
This command shows the provisioning status of
all installed or provisioned hardware.
show stack Command Modified Y Y Stacking
Commands
This command now shows provisioning details.
stack fallback-
config (Disabled)
Command Modified Y Y Stacking
Commands
This command has been disabled. To simplify
stack recovery, stub reconfiguration is now
achieved by using a trigger that is generated by
the type stack disabled-master command on
page 87.23.
switch provision Command New Y Y Stacking
Commands
This command enables you provide the
configuration for a new VCStack member
switch prior to physically connecting it to the
stack. To run this command, the stack position
must be vacant. The selected hardware type
must be compatible existing stack hardware.
GUI
Switching >
Power over
Ethernet
GUI tab New Y Y Appendix C:
GUI Reference
The Switching > Power over Ethernet menu
tab allows you to monitor and configure PoE on
your PoE switch. You can monitor PoE status,
and configure PoE ports and the PSE power.
Table 2: New and modified features and commands
Feature/
Command/
MIB
Ty p e Status
x600
x908/x900
Software
Reference
Chapter
Description