System information

C613-10501-01-REV B Software Release Note AlliedWare Plus Version 5.3.4-0.1 21
sflow enable Command New Y Y sFlow
Commands
This command enables sFlow® globally on the
switch. Note that sFlow cannot be enabled if Tx
port mirroring is enabled on any port on the
device.
sflow max-
header-size
Command New Y Y sFlow
Commands
This command sets the maximum header size
of the ethernet frames sampled on a specified
port. The maximum header size is measured in
bytes, referenced from the first byte of the
ethernet destination address and excludes the
ethernet FCS fields.
sflow polling-
interval
Command New Y Y sFlow
Commands
This command sets the sFlow® counter polling
interval (in seconds) for the specified ports. A
value of 0 disables polling. A counter sample is
taken every N seconds where N is the value
set by this command.
sflow sampling-
rate
Command New Y Y sFlow
Commands
This command sets the mean sFlow® sampling
rate for the specified ports. Sampling occurs
every N frames (on average), where N is the
rate value set via this command. The sampling
rate applies to ingress and egress frames
independently.
show debugging
sflow
Command New Y Y sFlow
Commands
This command displays sFlow® debug settings
for agent operation, and for sampling and
polling on specific interface ports. If no interface
ports are specified, sampling and polling will be
applied to all ports.
show running-
config sflow
Command New Y Y sFlow
Commands
This command displays the running system
information specific to the sFlow feature.
show sflow Command New Y Y sFlow
Commands
This command displays non-port-specific sFlow
agent configuration and operational status.
show sflow
interface
Command New Y Y sFlow
Commands
This command displays sFlow agent sampling
and polling configuration for specified ports.
undebug sflow Command New Y Y sFlow
Commands
This command applies the functionality of the
no debug sflow command.
VCStack
reboot rolling Command New Y Y Stacking
Commands
This command allows a stack to be rebooted in
a rolling sequence to minimize downtime. The
stack master is rebooted causing the remaining
stack members to failover and elect a new
master.
reload rolling Command New Y Y Stacking
Commands
This command performs the same function as
the reboot rolling command.
remote-login Command New Y Y Stacking
Commands
This command is used only on the master in
order to log onto the CLI of another stack
member. In most respects this the result is as if
being logged into the stack master. Config
commands are still broadcast to all stack
members, but show commands, and
commands that access the file system are
executed locally.
Table 2: New and modified features and commands
Feature/
Command/
MIB
Ty p e Status
x600
x908/x900
Software
Reference
Chapter
Description