System information

20 Software Release Note AlliedWare Plus Version 5.3.4-0.1 C613-10501-01-REV B
DHCP
clear ip dhcp
binding
Command New Y Y Dynamic Host
Configuration
Protocol
(DHCP)
Commands
On dynamically allocated bindings this
command clears either a specific lease binding,
or the lease bindings specified by the command.
SNMP
snmp-server
enable trap
Command Modified Y Y SNMP
Commands
This command can now enable the switch to
send DHCP snooping notifications (traps).
SNMP MIB
AT-DHCPSN-MIB MIB New Y Y SNMP MIBs This MIB contains objects for displaying and
managing DHCP snooping and ARP security
information on the switch.
Private MIBs MIB New Y Y SNMP MIBs Support for the sFlow Agent MIB has been
added.
Trigger Enhancements
type stack
disabled-master
Command New Y Y Tri gg er
Commands
This command (configured to the stack) selects
a pre-configured trigger that will activate on a
stack member if it becomes the disabled master.
sFlow
sFlow
Introduction
Feature New Y Y sFlow
Introduction
sFlow®1 provides the ability to monitor traffic
in data networks containing switches and
routers. This feature adds the sFlow Agent
capability.
debug sflow Command New Y Y sFlow
Commands
This command enables sFlow® debug message
logging, for sFlow sampling and polling activity
on the specified ports. If no ports are specified,
sampling and/or polling debug messages are
enabled for all ports.
debug sflow agent Command New Y Y sFlow
Commands
This command enables sFlow® debug message
logging that is not specific to particular ports.
For example, sending an sFlow datagram to the
collector.
sflow agent
(address)
Command New Y Y sFlow
Commands
This command sets the sFlow® agent IP
address on the switch. This address is inserted
into every sFlow datagram sent from the sFlow
agent switch, to the sFlow collector device. The
sFlow collector then use this address for SNMP
to uniquely identify and access the switch.
sflow collector
(address)
Command New Y Y sFlow
Commands
This command sets the sFlow® agent's
collector IP address and/or UDP port. This is
the destination IP address and UDP port, for
sFlow datagrams sent from the sFlow agent.
The IP address can be any valid IPv4 or IPv6
address.
sflow collector
max-datagram-
size
Command New Y Y sFlow
Commands
This command sets the maximum size of the
sFlow® datagrams sent to the collector.
Table 2: New and modified features and commands
Feature/
Command/
MIB
Ty p e Status
x600
x908/x900
Software
Reference
Chapter
Description