System information

16 Software Release Note AlliedWare Plus Version 5.3.4-0.1 C613-10501-01-REV B
ipv6 access-list
named TCP UDP
filter
Command Modified Y Y IPv6 Access
Control List
(ACL)
Commands
Use this ACL filter to add a filter entry for an
IPv6 source and destination address and prefix,
with TCP (Transmission Control Protocol) or
UDP (User Datagram Protocol) source and
destination ports specified, to the current
named IPv6 access-list. If a sequence number is
specified, the new entry is inserted at the
specified location. Otherwise, the new entry is
added at the end of the access-list.
ipv6 access-list
standard (named)
Command Modified Y Y IPv6 Access
Control List
(ACL)
Commands
This command configures an IPv6 standard
access-list for filtering frames that permit or
deny IPv6 packets from a specific source IPv6
address. The no variant of this command
removes a specified IPv6 standard access-list.
ipv6 access-list
standard IPv6
filter
Command New Y Y IPv6 Access
Control List
(ACL)
Commands
Use this ACL filter to add a filter entry for an
IPv6 source address and prefix length to the
current standard IPv6 access-list. If a sequence
number is specified, the new entry is inserted at
the specified location. Otherwise, the new
entry is added at the end of the access-list.
Authentication Enhancements
Authentication
Enhancements
Feature New Y Y Authentication
Configuration
The authentication enhancements introduced
in this release fall into three areas:
improvements to Web-authentication,
increased flexibility in the operation of the
Guest VLAN, and introduction of the auth-fail
VLAN.
Web-
authentication
Enhancements
Feature New Y Y Authentication
Configuration
These enhancements ensure that the client PC
user is presented with the Web-authentication
login page as soon as they start web browsing
to any address, irrespective of the IP
configuration on their PC.
Guest VLAN
Enhancements
Feature New Y Y Authentication
Configuration
Guest VLAN enhancements now allow routing
from the Guest VLAN to route
unauthenticated supplicant’s traffic to other
VLANs if required, and will relay their DHCP
requests to servers in other VLANs if required.
Failed
authentication
VLAN
Feature New Y Y Authentication
Configuration
The auth-fail VLAN feature allows the Network
Administrator to separate the supplicants who
attempted authentication, but failed, from the
supplicants who did not attempt authentication.
auth auth-fail vlan Command New Y Y Authentication
Commands
Use this command to enable the auth-fail vlan
feature on the specified vlan interface. This
feature assigns supplicants (client devices),
which have failed port authentication, to the
specified vlan interface.
Table 2: New and modified features and commands
Feature/
Command/
MIB
Ty p e Status
x600
x908/x900
Software
Reference
Chapter
Description