System information

C613-10501-01-REV B Software Release Note AlliedWare Plus Version 5.3.4-0.1 15
access-list
(standard
numbered) filter
Command New Y Y IPv4 Access
Control List
(ACL)
Commands
This ACL filter adds a source IP address filter
entry to a current standard numbered access-
list. If a sequence number is specified, the new
filter entry is inserted at the specified location.
Otherwise, the new filter entry is added at the
end of the access-list.
ipv6 access-list
extended
(named)
Command Modified Y Y IPv6 Access
Control List
(ACL)
Commands
Use this command when configuring an IPv6
extended access-list for filtering frames that
permit or deny IP, ICMP, TCP, UDP packets or
ICMP packets with a specific value based on the
source or destination. The no variant of this
command removes a specified IPv6 extended
access-list.
ipv6 access-list
extended IP
protocol filter
Command New Y Y IPv6 Access
Control List
(ACL)
Commands
Use this ACL filter to add a filter entry for an
IPv6 source and destination address and prefix,
with or without an IP protocol specified, to the
current extended IPv6 access-list. If a sequence
number is specified, the new entry is inserted at
the specified location. Otherwise, the new
entry is added at the end of the access-list.
ipv6 access-list
extended TCP
UDP filter
Command New Y Y IPv6 Access
Control List
(ACL)
Commands
Use this ACL filter to add a filter entry for an
IPv6 source and destination address and prefix,
with a TCP (Transmission Control Protocol) or
UDP (User Datagram Protocol) source and
destination port specified, to the current
extended IPv6 access-list. If a sequence number
is specified, the new entry is inserted at the
specified location. Otherwise, the new entry is
added at the end of the access-list.
ipv6 access-list
(named)
Command Modified Y Y IPv6 Access
Control List
(ACL)
Commands
Use this command to either create a new IPv6
hardware access-list, or to select an existing
IPv6 hardware access-list in order to apply a
filter entry to it. Use the no variant of this
command to delete an existing IPv6 hardware
access-list.
ipv6 access-list
named ICMP
filter
Command Modified Y Y IPv6 Access
Control List
(ACL)
Commands
Use this ACL filter to add a filter entry for an
IPv6 source and destination address and prefix,
for ICMP (Internet Control Message Protocol)
packets, to the current named IPv6 access-list. If
a sequence number is specified, the new entry
is inserted at the specified location. Otherwise,
the new entry is added at the end of the
access-list.
ipv6 access-list
named IPv6
protocol filter
Command Modified Y Y IPv6 Access
Control List
(ACL)
Commands
Use this ACL filter to add a filter entry for an
IPv6 source and destination address and prefix,
with an IP protocol type specified, to the
current named IPv6 access-list. If a sequence
number is specified, the new entry is inserted at
the specified location. Otherwise, the new
entry is added at the end of the access-list.
Table 2: New and modified features and commands
Feature/
Command/
MIB
Ty p e Status
x600
x908/x900
Software
Reference
Chapter
Description