System information

14 Software Release Note AlliedWare Plus Version 5.3.4-0.1 C613-10501-01-REV B
access-list
hardware ICMP
filter
Command New Y Y IPv4 Access
Control List
(ACL)
Commands
Use this ACL filter to add a new ICMP filter
entry to the current hardware access-list. If a
sequence number is specified, the new filter is
inserted at the specified location. Otherwise,
the new filter is added at the end of the access-
list.
access-list
hardware IP
protocol filter
Command New Y Y IPv4 Access
Control List
(ACL)
Commands
Use this ACL filter to add an IP protocol type
filter entry to the current hardware access-list. If
a sequence number is specified, the new filter is
inserted at the specified location. Otherwise,
the new filter is added at the end of the access-
list.
access-list
hardware MAC
filter
Command New Y Y IPv4 Access
Control List
(ACL)
Commands
Use this ACL filter to add a MAC filter entry to
the current hardware access-list. If a sequence
number is specified, the new filter is inserted at
the specified location. Otherwise, the new filter
is added at the end of the access-list.
access-list
hardware TCP
UDP filter
Command New Y Y IPv4 Access
Control List
(ACL)
Commands
Use this ACL filter to add a TCP or UDP filter
entry to the current hardware access-list. The
filter will match on any TCP or UDP type
packet that has the specified source and
destination IP addresses. The parameter any
may be specified if an address does not matter.
If a sequence number is specified, the new filter
is inserted at the specified location. Otherwise,
the new filter is added at the end of the access-
list.
access-list
standard (named)
Command Modified Y Y IPv4 Access
Control List
(ACL)
Commands
This command has been modified. This
command configures a standard named access-
list that permits or denies packets from a
specific source IP address. You can either create
a standard named ACL together with an ACL
filter entry in the Global Configuration mode,
or you can use the IPv4 Standard ACL
Configuration mode for sequenced ACL filter
entry.
access-list
(standard
numbered)
Command Modified Y Y IPv4 Access
Control List
(ACL)
Commands
This command has been modified. This
command configures a standard numbered
access-list that permits or denies packets from a
specific source IP address. You can either create
a standard numbered ACL together with an
ACL filter entry in the Global Configuration
mode, or you can use the IPv4 Standard ACL
Configuration mode for sequenced ACL filter
entry.
access-list
standard (named)
filter
Command New Y Y IPv4 Access
Control List
(ACL)
Commands
This ACL filter adds a source IP address filter
entry to a current standard access-list. If the
sequence number is specified, the new filter
entry will be inserted at the specified location.
Otherwise, the new entry is added at the end
of the access-list.
Table 2: New and modified features and commands
Feature/
Command/
MIB
Ty p e Status
x600
x908/x900
Software
Reference
Chapter
Description