System information

C613-10501-01-REV B Software Release Note AlliedWare Plus Version 5.3.4-0.1 13
access-list
extended
(named)
Command Modified Y Y IPv4 Access
Control List
(ACL)
Commands
This command has been modified. This
command configures an extended named
access-list that permits or denies packets from
specific source and destination IP addresses.
You can either create an extended named ACL
together with an ACL filter entry in the Global
Configuration mode, or you can use the IPv4
Extended ACL Configuration mode for
sequenced ACL filter entry.
access-list
(extended
numbered)
Command Modified Y Y IPv4 Access
Control List
(ACL)
Commands
This command has been modified. This
command configures an extended numbered
access-list that permits or denies packets from
specific source and destination IP addresses.
You can either create an extended numbered
ACL together with an ACL filter entry in the
Global Configuration mode, or you can use the
IPv4 Extended ACL Configuration mode for
sequenced ACL filter entry.
access-list
extended ICMP
filter
Command New Y Y IPv4 Access
Control List
(ACL)
Commands
Use this ACL filter to add a new ICMP filter
entry to the current extended access-list. If the
sequence number is specified, the new filter is
inserted at the specified location. Otherwise,
the new filter is added at the end of the access-
list.
access-list
extended IP filter
Command New Y Y IPv4 Access
Control List
(ACL)
Commands
Use this ACL filter to add a new IP filter entry
to the current extended access-list. If the
sequence number is specified, the new filter is
inserted at the specified location. Otherwise,
the new filter is added at the end of the access-
list.
access-list
extended IP
protocol filter
Command New Y Y IPv4 Access
Control List
(ACL)
Commands
Use this ACL filter to add a new IP protocol
type filter entry to the current extended
access-list. If the sequence number is specified,
the new filter is inserted at the specified
location. Otherwise, the new filter is added at
the end of the access-list.
access-list
extended TCP
UDP filter
Command New Y Y IPv4 Access
Control List
(ACL)
Commands
Use this ACL filter to add a new TCP or UDP
filter entry to the current extended access-list.
If the sequence number is specified, the new
filter is inserted at the specified location.
Otherwise, the new filter is added at the end of
the access-list.
access-list
hardware
(named)
Command New Y Y IPv4 Access
Control List
(ACL)
Commands
This command creates a named hardware
access-list that can be applied to a switch port
interface. ACL filters for a named hardware
ACL are created in the IPv4 Hardware ACL
Configuration mode. The no variant of this
command removes the specified named
hardware ACL.
Table 2: New and modified features and commands
Feature/
Command/
MIB
Ty p e Status
x600
x908/x900
Software
Reference
Chapter
Description