System information

12 Software Release Note AlliedWare Plus Version 5.3.4-0.1 C613-10501-01-REV B
show ip bgp
neighbors sent-
msgs
Command New Y Y BGP
Commands
This command displays the number of
messages sent to the neighbor from the peer
throughout the session.
show ip bgp
neighbors update
Command New Y Y BGP
Commands
This command displays the number of update
messages sent to the neighbor from the peer
throughout the session.
timers (BGP) Command Modified Y Y BGP
Commands
This command sets the BGP keepalive timer
and holdtime timer values. The default
keepalive value has changed from 60 to 30
seconds and the default holdtime value has
changed from 180 to 90 seconds.
PIM
show ip pim
sparse-mode
interface
Command Modified N Y PIM-SM
Commands
The output displayed by this command has
changed. With the base license, the maximum
number of PIM-SM interfaces that can be
configured is 31.
With a feature license a maximum of 100
interfaces are available. The show output will
display the number of interfaces that can be
configured in the “maximum allowed” field.
show ip pim
dense-mode
interface
Command Modified N Y PIM-DM
Commands
The output displayed by this command has
changed. With the base license, the maximum
number of PIM-SM interfaces that can be
configured is 32.
With a feature license a maximum of 100
interfaces are available. The show output will
display the number of interfaces that can be
configured in the “maximum allowed” field.
ACL Sequence Number Support
ACL Sequence
Number Support
Feature New Y Y Access
Control Lists
Introduction
To help you manage ACLs you can apply
sequence numbers to filters. This allows you to
remove filters from named and numbered
ACLs without having to reconfigure an ACL.
The ability to add sequence numbers to filters
simplifies updates through the ability to position
a filter within an ACL. When you add a new
filter, you can specify a sequence number to
position the filter in the ACL and you can also
remove a current filter in an ACL by specifying a
sequence number.
access-group Command New Y Y IPv4 Access
Control List
(ACL)
Commands
This new command replaces the existing ip
access group and mac access group
commands. This command adds (or removes) a
hardware-based numbered or named access-
list to a switch port interface. This command
works in both Global Configuration and
Interface Configuration modes to apply
hardware access-lists to all switch port
interfaces or selected switch port interfaces
respectively.
Table 2: New and modified features and commands
Feature/
Command/
MIB
Ty p e Status
x600
x908/x900
Software
Reference
Chapter
Description