System information

10 Software Release Note AlliedWare Plus Version 5.3.4-0.1 C613-10501-01-REV B
RIPng
cisco-metric-
behavior (RIPng)
Command New Y Y RIPng
Commands
Use this command to enable or disable the
RIPng routing metric update to conform to
Cisco’s implementation. The Cisco
implementation sets the metric of redistributed
connected and static RIPng routes to 0 by
default. AlliedWare Plus sets this metric to 1 by
default when using the default-metric
command.
OSPF
enable db-
summary-opt
Command New Y Y OSPF
Commands
This command enables OSPF database
summary list optimization.
network area Command Modified Y Y OSPF
Commands
Use this command to enable OSPF routing with
a specified Area ID on interfaces with IP
addresses that match the specified network
address.
passive-interface
(OSPF)
Command Modified Y Y OSPF
Commands
Use this command to suppress the sending of
Hello packets on all interfaces, or on a specified
interface. If you use the passive-interface
command without the optional parameters
then all interfaces are put into passive mode.
timers spf exp Command New Y Y OSPF
Commands
Use this command to adjust route calculation
timers using exponential back-off delays.
BGP
BGP
Authentication
Feature New Y Y BGP
Configuration
BGP authentication allows users to receive
selected routing information, enhancing security
of their network traffic. When BGP
authentication is enabled on a peer, the peer
verifies routing packet it receives by exchanging
a password that is configured on both the
sending and the receiving peers.
Configuring BGP
Graceful Reset
Feature New Y Y BGP
Configuration
The graceful restart feature for BGP session
reset is used so that any changes in network
configuration do not affect packet forwarding.
The graceful restart feature invokes graceful
restart only when a configuration change forces
a peer reset.
Configuring BGP
Graceful Restart
Feature New Y Y BGP
Configuration
Using BGP graceful restart, the data forwarding
plane of the device can continue to process and
forward packets even if the control plane,
which is responsible for determining best paths,
fails
bgp bestpath med
remove-recv-med
Command New Y Y BGP
Commands
This command removes the Multi Exit
Discriminator (MED) attribute from the update
messages received by the BGP speaker from its
peers.
bgp bestpath med
remove-send-
med
Command New Y Y BGP
Commands
This command removes the Multi Exit
Discriminator (MED) attribute from the update
messages sent by the BGP speaker from its
peers.
Table 2: New and modified features and commands
Feature/
Command/
MIB
Ty p e Status
x600
x908/x900
Software
Reference
Chapter
Description