User Manual

AlliedView™-EMS 4.0.3 Device Management Guide Page 440 of 468
LED State Description
DUP
Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
LT Green Link Test is enabled
OAMB Green OAM Bypass is enabled
OAMV Green OAM Visible is enabled
LCDS Green Line Card Dip Switch is enabled
Note - The current firmware version will not allow remote port connection on the RJ-45
port if the SFP port is set to disabled.
Note - The Module Name parameter always displays 'yyyyyyyy' as its default value when
not yet configured.
Note - AT-CV5M01: The current firmware version does not allow the Port Mode
parameter of FX type of ports to be configured. Attempting to configure this parameter
other than its current Port Mode value will result in the error message: "noSuchName."
Remote Line Card Info
Note - Even if the current firmware version allows the Remote Port Mode
parameter to be configured to certain values, this parameter should not be
configured for the 100Base-FX port.
Port Info
Note - The value of the Port Speed and Port Duplex parameters of a port with an
established link automatically changes to '10Mbps' and 'half duplex' when the value
of its Port Mode parameter is changed from 'auto' to 'manual'.
Note - The current firmware version does not allow Device Manager to configure
or display information on the T1/E1 port of the AT-CM70S.
Note - The value of the Port Speed and Port Duplex parameters of a port with an
established link automatically changes to '10Mbps' and 'half duplex' when the value
of its Port Mode parameter is changed from 'auto' to 'manual'.
Note - The current firmware version does not allow the Port Ingress Rate Limit and
Port Egress Rate Limit parameters to be configured.
Context Menu
Note - Selecting the Telnet option in the RS-232 Terminal Port Context Menu of the
AT-CM70S will establish a Telnet session to the AT-CV5M01 management module.