User Manual

AlliedView™-EMS 4.0.3 Device Management Guide Page 359 of 468
Note - When multiple units of the AT-x900-12X series are stacked together,
the 'Base Ports' submenu is displayed even if the AT-XEM-STK is the only
installed XEM module in the device.
Error Statistics
Displays error statistics.
Note - The Ethernet Chipset parameter is not applicable to the AT-x900-12X series
and should be ignored.
Note - When multiple units of the AT-x900-12X series are stacked together, the
'Base Ports' submenu is displayed even if the AT-XEM-STK is the only installed XEM
module in the device.
Received Address
Displays the address for which the system will accept packets/frames on the
particular interface.
Note - The Received Address parameter is not applicable to the AT-x900-12X series
and should be ignored.
Note - The Received Address Status and Received Address Type parameters are
implemented as 'read-only'.
Note - When multiple units of the AT-x900-12X series are stacked together, the
'Base Ports' submenu is displayed even if the AT-XEM-STK is the only installed XEM
module in the device.
Spanning Tree Info
Standard
Displays the port's spanning tree parameters.
Note - Valid MIB Set values for the Port Path Cost parameter is in the range
[1-65535] inclusive.
Note - The current firmware version does not allow the Port parameter to
be configured.
Note - The current firmware version does not allow the Port Priority, Port,
Port Path Cost and Path Cost Contribution parameters to be configured.
Note - When multiple units of the AT-x900-12X series are stacked together,
the 'Base Ports' submenu is displayed even if the AT-XEM-STK is the only
installed XEM module in the device.