User Manual

AlliedView™-EMS 4.0.3 Device Management Guide Page 281 of 468
Interface Config
Displays the list of subnets which require separate configuration in Routing
Information Protocol.
Note - The current firmware version does not allow the Domain and Default
Metric parameters to be configured.
Note - Valid MIB Set values for the Row Status parameter are 'active' and 'not
in service'. Attempting to set this parameter to any other value will result in
the error message: "The error occurred with 'Set' operation. Error: bad
value".
Note - The current firmware version does not allow the following parameters
to be configured:
• Domain
• Authentication Key
• Default Metric
• Source IP Address
Active Peer Info
Displays information about active peer relationships.
OSPF
Basic Info
Displays basic information about Open Shortest Path First routing protocol.
Note - The current firmware version does not allow the following parameters to be
configured:
• AS Border Router Status
• Type of Service Support Status
• Ext Link State DB Limit
• Multicast Extensions
• Exit Overflow Interval
• Demand Extensions
Area Info
Displays the configured parameters and cumulative statistics of the device's
attached areas.
Note - The Authentication Type parameter is not applicable to the AT-9700
Series and should be ignored.
Stub Area Config
Displays the set of metrics that will be advertised by a default Area Border
Router into a stub area.