User Manual

AlliedView™-EMS 4.0.3 Device Management Guide Page 158 of 468
• Received DEs
• Sent DEs
• Logical Interface Index
• Row Status
Note - The following parameters are implemented as 'read-only':
• State
• CIR
• Maximum Line Speed
• Throughput
Errors
Displays information about errors related to the Frame Relay module.
Note - The Faults and Fault Time parameters are not applicable to the AT-
AR700S series and should be ignored.
DS1
DS1 Config
Displays DS1 configuration.
Note - The current firmware version returns a 'noSuchName' value for the
Port Number parameter.
Note - The following parameters are implemented as 'read-only':
• Line Type
• Line Coding
• Send Code
• Circuit ID
• Loopback Config
• Signal Mode
• Transmit Clock Source
• Facilities Data Link
• Line Length
• Change Status Trap
• Channelization
Near-End
Current 15-Min Interval Statistics
Displays near-end DS1 statistics every 15 minutes.
Statistics for Past 24 Hours
Displays near-end DS1 statistics for the past 24 hours.