Manual

AlliedView™-EMS 4.0.2 Device Management Guide Page 412 of 441
Note - The value of the Port Speed parameter of a port with an established link
automatically changes to '10Mbps' when the value of its Port Mode parameter is
changed from 'auto' to 'manual'.
Note - The current firmware version does not allow the Port Ingress Rate Limit and
Port Egress Rate Limit parameters to be configured.
Note - AT-CV5M01: The current firmware version does not allow Port Speed and
Port Duplex Status parameters to be set to '1Gbps' and 'unknown' values
respectively.
AT-CM70S
4 x TI/E1 + 10/100TX over SFP-based fiber.
LED State Description
DUP
Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
LT Green Link Test is enabled
OAMB Green OAM Bypass is enabled
OAMV Green OAM Visible is enabled
LCDS Green Line Card Dip Switch is enabled
Note - The current firmware version will not allow remote port connection on the RJ-45
port if the SFP port is set to disabled.
Note - The Module Name parameter always displays 'yyyyyyyy' as its default value when not
yet configured.