Manual

AlliedView™-EMS 4.0.2 Device Management Guide Page 278 of 441
Note - The current firmware version does not allow the Datagram TTL Threshold
parameter to be configured.
Scope Name Info
Displays the list of multicast scope names.
Note - The Scope Name Info sub-menu option does not display the correct
parameters. Instead, it displays the sub-menu option name as a parameter with a
value of 'noSuchName'.
Scope Boundary Info
Displays a list of the device's scoped multicast address boundaries.
Note - The Scope Boundary Info sub-menu option does not display the correct
parameters. Instead, it displays the sub-menu option name as a parameter with a
value of 'noSuchName'.
Route Table
Displays the table containing multicast routing information for IP datagrams sent by
particular sources to the IP multicast groups known to this device.
Note - The Route Table sub-menu option does not display the correct parameters.
Instead, it displays the sub-menu option name as a parameter with a value of
'noSuchName'.
Next Hop Table
Displays the table containing information on the next hops on outgoing interfaces
for routing IP multicast datagrams.
Note - The Next Hop Table sub-menu option does not display the correct
parameters. Instead, it displays the sub-menu option name as a parameter with a
value of 'noSuchName'.
BOOTP Relay
Basic Info
Displays basic information about the BOOTP relay function.
Note - Valid MIB set values for the Hop Count parameter are in the range [0-16]
inclusive.
Interface Info
Displays information about a specific IP address as a destination to forward BOOTP
packets to.
DNS Relay
Basic Info
Displays basic information about the DNS relay function.