Manual

AlliedView™-EMS 4.0.2 Device Management Guide Page 154 of 441
Note - The DLCMI Status and Row Status parameters are not applicable to the AT-
AR700S series and should be ignored.
Note - The following parameters are implemented as 'read-only':
  DLCMI State
  Address Type
  Address Length
  Polling Interval of Successive Status
  Polling Interval of Full Status Enquiry
  Error Threshold
  Monitored Error Events
  Max Supported VC Numbers
  Multicast Type
Virtual Circuits
Displays Frame Relay circuit statistics.
Note - The following parameters are not applicable to the AT-AR700S series and
should be ignored:
  Multicast Type
  Type
  Discards
  Received DEs
  Sent DEs
  Logical Interface Index
  Row Status
Note - The following parameters are implemented as 'read-only':
  State
  CIR
  Maximum Line Speed
  Throughput
Errors
Displays information about errors related to the Frame Relay module.
Note - The Faults and Fault Time parameters are not applicable to the AT-AR700S
series and should be ignored.
DS1
DS1 Config
Displays DS1 configuration.
Note - The current firmware version returns a 'noSuchName' value for the Port
Number parameter.