Manual

AT-CV10x
AT-CV101: 10/100TX to 100FX (ST, 2km, MM)
AT-CV102: 10/100TX to 100FX (SC, 2km, MM)
AT-CV102/1: 10/100TX to 100FX (SC, 15km, SM)
AT-CV102/2: 10/100TX to 100FX (SC, 40km, SM)
LED State Description
LT Green Link Test is enabled
SML Green Smart Missing Link is enabled
ML Green Missing Link is enabled
LCDS Green Line Card Dip Switch is enabled
Module Info
Note -The current firmware version does not return the correct value for the
Module MAC Address parameter.
Note - AT-CV5M01: Configuring the Module Operation Mode parameter will result
in the error message: "The error occurred with 'Set' operation. Error: time out
occurred".
Port Info
Note - The current firmware version does not allow any of the parameters under
this table to be configured.
AlliedView™-EMS 4.0.1 Device Management Guide Page 384 of 411