Manual

AlliedView™-EMS 4.0.1 Device Management Guide Page 381 of 411
LED State Description
OAMB Green OAM Bypass is enabled
OAMV Green OAM Visible is enabled
LCDS Green Line Card Dip Switch is enabled
N
yet configured.
Note - AT-CV5M01: The current firmware version does not allow the Port Mode
ote - The Module Name parameter always displays 'yyyyyyyy' as its default value when not
rameter of FX type of ports to be configured. Attempting to configure this parameter
n its current Port Mode value will result in the error message: "noSuchName."
nfo
en the settings of the port to which it is
e value of its Port Mode parameter is
d from 'auto' to 'manual'.
AT-CM2K0S
pa
other tha
Port I
Note - The value of the Port Mode parameter of a port with an established link
automatically changes to 'auto' wh
connected are modified.
Note - The value of the Port Speed parameter of a port with an established link
automatically changes to '10Mbps' when th
change
10/100/1000T to SFP
LED State Description
DUP
Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
LT Green Link Test is enabled
SML Green Smart Missing Link is enabled
ML Green Missing Link is enabled
OAMB Green OAM Bypass is enabled
OAMV Green OAM Visible is enabled
LCDS Green Line Card Dip Switch is enabled
Note - The Module Name parameter always displays 'yyyyyyyy' as its default value when not