Owner manual

AlliedView™-EMS 3.11 QoS Manager User’s Guide Page 94 of 146
Property
Name
Description Valid Values
Class class maxbandwidth setting. • YES
Ignore
Bandwidth
Class
Determines whether or not the
metering stage acknowledges any
previous bandwidth class assigned
to flows processed by the default
traffic class.
• NO
• YES
Mark Value Specifies an explicit value to use
as an index into the DSCPMAP
table when the premarking
parameter is usemarkvalue.
• 0-63
• none
Maximum
Bandwidth
Specifies the maximum bandwidth
available to the traffic class.
This can be set by entering a value using
one the following formats:
• 0-16000000 kbps
• 0-16000 Mbps (decimal point
supported)
• 0-16 Gbps (decimal point
supported)
• none
Max Burst Size Specifies the burst tolerance for
the Maximum Bandwidth
parameter.
This can be set by entering a value using
one the following formats:
• 0-16777216 bytes
• 0~16384 KB (decimal point
supported)
• 0~16 MB (decimal point
supported)
• 0~0.015628 GB (decimal point
supported)
Note - Byte measures can have the value
b,k,kb,m,mb,g,gb (case insensitive)
Minimum
Bandwidth
Specifies the minimum bandwidth
reserved for the traffic class.
This can be set by entering a value using
one the following formats:
• 0-16000000 kbps
• 0-16000 Mbps (decimal point
supported)
• 0-16 Gbps (decimal point
supported)
• none
Min Burst Size Specifies the burst tolerance for This can be set by entering a value using