Owner manual

AlliedView™-EMS 3.11 QoS Manager User’s Guide Page 74 of 146
Property
Name
Description Valid Values
the Minumum Bandwidth, or for
the Maximum Bandwidth when
the Minimum Bandwidth is none.
one the following formats:
• 0-16777216 bytes
• 0~16384 KB (decimal point
supported)
• 0~16 MB (decimal point
supported)
• 0~0.015628 GB (decimal point
supported)
Note - Byte measures can have the value
b,k,kb,m,mb,g,gb (case insensitive)
Premarking Specifies the QoS action to take
on the traffic class before
bandwidth metering is applied.
• USEMARKVALUE
• USEDSCP
• none
Remarking Specifies the action to take after
the metering stage.
• USEDSCPMAP
• BWCLASS
• none
Storm Status Determines whether or not
Storm Protection is enabled for
the default traffic class.
• enabled
• disabled
Storm Window Specifies the time between the
polling of traffic class counters
that checks whether storm
protection should be activated.
Required when storm protection
is enabled.
This value can be set by entering a
number from 100-60000.
This value can also be set to "none".
Storm Rate Storm protection is activated
when this rate of traffic is
exceeded. Required when storm
protection is enabled.
This value can be set by entering a value
from 1Kbps up to 10Gbps.
The value may contain decimal fractions
up to 3 decimal places.
This value can also be set to "none".
Storm Action Specifies the action QoS takes
when a storm is detected on a
port.
• PORTDISABLE
• LINKDOWN
• VLANDISABLE
Storm Timeout Specifies the length of time the
port remains disabled after a
storm is detected.
This value can be set by entering a
number from 1-86400.
This value can also be set to "none".
VLAN Specifies the VLAN where
unclassified traffic is sent when
action is sendvlanport. Traffic is
This can be set by selecting from a list of
available VLANs.