Owner manual

AlliedView™-EMS 3.11 QoS Manager User’s Guide Page 38 of 146
Property Name Description Valid Values
Source MAC
Address
Specifies the source MAC address
of the packet.
This can be set by entering a MAC
address string using the following
format:
• XX-XX-XX-XX-XX-XX
This can also be set to "any".
Destination MAC
Address
This parameter specifies the
destination MAC address of the
packet.
This can be set by entering a MAC
address string using the following
format:
• XX-XX-XX-XX-XX-XX
This can also be set to "any".
Match1 Specifies the actual data to match This can be set by entering a 2-byte
hex number. (0000-FFFF)
Mask1 Specifies whether the corresponding
bit in the Match1 parameter is "on"
for a match or "don't care" for a
match.
This can be set by entering a 2-byte
hex number. (0000-FFFF)
Offset1 Specifies the location or offset
where the pattern for Match1 is to
be checked.
Range: 0-62
Match2 Specifies the actual data to match This can be set by entering a 2-byte
hex number. (0000-FFFF)
Mask2 Specifies whether the corresponding
bit in the Match2 parameter is "on"
for a match or "don't care" for a
match.
This can be set by entering a 2-byte
hex number. (0000-FFFF)
Offset2 Specifies the location or offset
where the pattern for Match2 is to
be checked.
Range: 0-62
Match3 Specifies the actual data to match This can be set by entering a 2-byte
hex number. (0000-FFFF)
Mask3 Specifies whether the corresponding
bit in the Match3 parameter is "on"
for a match or "don't care" for a
match.
This can be set by entering a 2-byte
hex number. (0000-FFFF)
Offset3 Specifies the location or offset
where the pattern for Match3 is to
be checked.
Range: 0-62
Protocol Specifies the protocol of the packet. This can be set by selecting any of
the following values:
• IP
• IPv6