Owner manual

AlliedView™-EMS 3.11 QoS Manager User’s Guide Page 131 of 146
Property Name Description Valid Values
• SAP
• RIP
• NNB
• DIAG
• NLSP
• IPXWAN
• any
Destination IPX
Socket
Specifies the destination IPX socket
number of an IPX packet
This can be set by entering a 4-byte
hexadecimal value (0000-FFFF) or by
selecting one of the following:
• NCP
• SAP
• RIP
• NNB
• DIAG
• NLSP
• IPXWAN
• any
Match1 Specifies the actual data to match This can be set by entering a 4-byte
hex number. (0000-FFFF)
Mask1 Specifies whether the corresponding
bit in the Match1 parameter is "on"
for a match or "don't care" for a
match.
This can be set by entering a 4-byte
hex number. (0000-FFFF)
Offset1 Specifies the location or offset
where the pattern for Match1 is to
be checked.
Range: 0-62
Match2 Specifies the actual data to match This can be set by entering a 4-byte
hex number. (0000-FFFF)
Mask2 Specifies whether the corresponding
bit in the Match2 parameter is "on"
for a match or "don't care" for a
match.
This can be set by entering a 4-byte
hex number. (0000-FFFF)
Offset2 Specifies the location or offset
where the pattern for Match2 is to
be checked.
Range: 0-62
Match3 Specifies the actual data to match This can be set by entering a 4-byte
hex number. (0000-FFFF)
Mask3 Specifies whether the corresponding
bit in the Match3 parameter is "on"
for a match or "don't care" for a
match.
This can be set by entering a 4-byte
hex number. (0000-FFFF)