User Manual

AlliedView™-EMS 3.11 Device Management Guide Page 331 of 402
AT-CM70S
4 x TI/E1 + 10/100TX over SFP-based fiber.
LED State Description
DUP
Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
LT Green Link Test is enabled
OAMB Green OAM Bypass is enabled
OAMV Green OAM Visible is enabled
LCDS Green Line Card Dip Switch is enabled
Note - The current firmware version will not allow remote port connection on the RJ-45
port if the SFP port is set to disabled.
Remote Line Card Info
Note - Even if the current firmware version allows the Remote Port Mode
parameter to be configured to certain values, this parameter should not be
configured for the 100Base-FX port.
Port Info
Note - The value of the Port Speed and Port Duplex parameters of a port with an
established link automatically changes to '10Mbps' and 'half duplex' when the value of
its Port Mode parameter is changed from 'auto' to 'manual'.