User Manual

Property
Name
Description Valid Values
is to be checked.
Match3 Specifies the actual data to
match
This can be set by entering a 2-
byte hex number. (0000-FFFF)
Mask3 Specifies whether the
corresponding bit in the
Match3 parameter is "on" for a
match or "don't care" for a
match.
This can be set by entering a 2-
byte hex number. (0000-FFFF)
Offset3 Specifies the location or offset
where the pattern for Match3
is to be checked.
Range: 0-62
Protocol Specifies the protocol of the
packet.
This can be set by selecting any
of the following values:
• IP
• IPv6
• ARP
• IPX
• NONIPIPX
• any
This can also be set by entering
a 1- to 5- byte hexadecimal
value (00-FFFFFFFFFF).
Source TCP
Port
Specifies the TCP source port
of a TCP/IP packet.
Range: any, 0-65535 or a port
range (n-m).
Destination
TCP Port
Specifies the TCP destination
port of a TCP/IP packet.
Range: any, 0-65535 or a port
range (n-m).
TCP Flags Specifies the TCP flags of a
TCP/IP packet.
This can be set by selecting one
or more of the following values:
• URG
• ACK
• RST
• SYN
• FIN
• any
Source UDP
Port
Specifies the UDP source port
of an UDP/IP packet.
Range: any, 0-65535 or a port
range (n-m).
Destination
UDP Port
Specifies the UDP destination
port of an UDP/IP packet.
Range: any, 0-65535 or a port
range (n-m).
AlliedView™-EMS 3.10 QoS Manager User’s Guide Page 48 of 128