User's Manual

BGP and BGP4+ Configuration
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 2.33
Router 2
awplus#
configure terminal
Enter the Global Configuration mode.
awplus(config)#
router bgp 11
Define the BGP4+ routing process. The number 11
specifies the Autonomous System (AS) number of Router
2.
awplus(config-router)#
bgp router-id 192.168.10.11
Configure a fixed Router ID (192.168.10.11) for the
BGP4+ routing process.
awplus(config-router#
neighbor 2001:db8::10:10 remote-as
10
Define BGP4+ neighbor Router 1, and establish a TCP
session by specifying the global unicast IPv6 address
(2001:db8::10:10) and the AS number (10) of
neighbor Router 1.
awplus(config-router)#
address-family ipv6
Enter IPv6 Address Family Configuration mode for
configuring routing sessions that use IPv6 address
prefixes.
awplus(config-router-af)#
network 2001:db8:11::/48
Announces IPv6 network prefix 2001:db8:11::/48.
Running show ipv6 bgp command on Router 1
displays Router 1 receiving 2001:db8:11::/48
packets.
awplus(config-router-af)#
network 2001:db8:12::/48
Announces IPv6 network prefix 2001:db8:12::/48.
Running show ipv6 bgp command on Router 1
displays Router 1 rejecting 2001:db8:12::/48
packets.
awplus(config-router-af)#
neighbor 2001:db8::10:10 activate
Activate the exchange of information to the peer
(neighbor) Router 1 (2001:db8::10:10) and enable
the exchange of IPv6 address prefix types with this
neighbor. Note that other information apart from prefixes
is sent in updates. This command activates the exchange
of information for the peer defined.
awplus(config-router-af)#
exit-address-family
Exit IPv6 Address Family Configuration mode, and return
to the Router Configuration mode.
awplus(config-router)#
exit
Exit the Router Configuration mode, and return to the
Global Configuration mode.