User's Manual

Chapter 3: Manage Menu

but only on the one to be used for the bridge. For example, if you are

planning to use the 2.4 GHz radio for the bridge, you should activate

access point detection on that radio. For instructions, refer to “Viewing

Neighboring Access Points” on page 120.

After performing steps 1 to 5, do one of the following:

 If the radios in the other access point of the bridge are already

enabled, continue with this procedure.

 If the radios in the other access point of the bridge are disabled,

the default setting, end your current management session, start a

new management session on the other unit, and repeat this

procedure.

Configuring the

WDS Bridge

To configure the WDS bridge settings, perform the following procedure:

1. Select WDS from the Manage menu.

The access point displays the “Configure WDS bridges to other access

points” window, shown in Figure 19.

Figure 19. Configure WDS Bridges to Other Access Points Window