User's Manual

AT-TQ2403 Management Software User's Guide 213
AT-TQ240
3# get log
Property Value
----------------------------------
depth 128
persistence no
severity 7
relay-enabled 0
relay-host
relay-port 514
When you start a new AP, the Log Relay Host is disabled. From the above output for the "get log"
command, you can identify the following about the Log Relay Host (syslog server):
 The syslog server is disabled (because "relay-enabled" is set to "0")
 No IP address or Host Name is specified for the syslog server.
 The AP is listening for syslog messages on the default port 514
Enable / Disable Log Relay Host
To enable the Log Relay Host:
AT-TQ2403# set log relay-enabled 1
To disable the Log Relay Host:
AT-TQ2403# set log relay-enabled 0
Specify the Relay Host
To specify the Relay Host, provide either the IP Address or a DNS name for the Log Relay Host as
parameters to the "set log relay-host" command as shown below.

Note: If you are using AT-TQ2403 Wire
less Operations Center, the Repository Server
should receive the syslog messages from all access points. In this case, use the IP address of
the Operations Center Repository Server as the Relay Host.
 To specify an IP address for the syslog server:
set log relay-host IP_Address_Of_LogRelayHost
Where IP_Address_Of_LogRelayHost is the IP Address of the Log Relay Host.
For example:
AT-TQ2403# set log relay-host 10.10.5.220
 To specify a Host Name for the syslog server:
set log relay-host Host_Name_Of_LogRelayHost
Where Host_Name_Of_LogRelayHost is the DNS name for the Log Relay Host.
For example: