User's Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- Chapter 4
- Chapter 5
- Chapter 6
- Chapter 7
- Appendix A
- Appendix B
- Contents
- Chapter 1
- Chapter 2
- Chapter 3
- Chapter 4
- Chapter 5
- Chapter 6
- Chapter 7
- Appendix A
- Appendix B
AT-2701 Series Fast Ethernet Adapter Installation Guide
67
Speed/Duplex
The Speed/Duplex property sets the link speed and duplex mode of the
adapter.
To change the Speed/Duplex property, do the following:
1. Access the Advanced Properties.
See “Accessing Advanced Properties” on page 60.
2. Select Speed/Duplex in the Property box.
The Speed/Duplex page is displayed as shown in Figure 35.
Figure 35. Speed/Duplex Page
3. Select one of the following options:
(1) 100Mb/Half Duplex
(2) 100Mb/Full Duplex — This is the default setting.
4. Click OK.