Installation and Operation Manual

SIGALARM INSTALLATION AND OPERATION MANUAL / GENERATION 4 WIRELESS / VERSION 4.2

7.3 POWER SUPPLY REQUIREMENTS

12-48 Volt

7.4 E-FIELD DETECTION

Electric Field 60 Hz or 50Hz

**selector switch located on board** default is 60Hz

7.5 RANGE OF EFFECTIVENESS

Voltage Detection – Between 10 to 200 feet depending on voltage

Zigbee Communication – 27 meters (between sensors and control module)

7.6 SENSOR BATTERY

Each sensor is equipped with a lithium polymer battery that should last

approximately 660 hours with no sunlight. Variables such as extreme heat or

FROGZLOOD΍HFWHVWLPDWHGEDWWHU\OLIH7KHVRODUSDQHOVZLOOFRQWLQXDOO\FKDUJH

this battery for years. Completely dead batteries will take approximately 24

hours to charge (at approximately 100 milliamps per hour). If the battery is

allowed to run down to 3.0 volts or less the sensor will enter self-preservation

mode and shut down. The sensor will resume operations at 3.2 volts and, is

considered fully charged at 3.75 volts.

The sensor battery can be charged using any micro USB. Plug the USB in the (J1)

port. The switch must be in the on position to charge the battery.

7.7 CONTROL MODULE SCREEN

5.7 Full color display, High Brightness 900 Nits, 640 x 480 res.

7.8 TEMPERATURE SPECIFICATIONS

-10° c to +70°c

7.9 SPEAKER

Freq Resp: 300-15 kHz

Power Rating 15W max

Sensitivity: 105dB / 1W/1M