Installation and Operation Manual

23
SIGALARM INSTALLATION AND OPERATION MANUAL / GENERATION 4 WIRELESS / VERSION 4.2
Radio Frequency Selector: This feature allows you to select which radio frequency
the control module will utilize. The control module and sensors must be set on the
same frequency to communicate. 916 is the factory default. Use the bottom right
corner to select the dropdown menu and assign the preferred radio frequency.
In the USA and Canada, users may only select the radio frequencies of 906MHz,
908MHz, 910MHz, 912MHz, 914MHz, 916 MHz, 918MHz, 920MHz, 922MHz, or 924MHz.
Select the matching
radio frequency by
turning the dial on
the sensor to the
desired position.
Use the table printed
on the sensor board
as a guide.
3.10 DISPLAY SETTINGS
3.11 SETUP DEFAULTS
Item Action Screen Function
2 Display Icon Adjust brightness
Item Action Screen Function
3 Set Up Icon Language preference, default English, software version,
hardware version,