Installation and Operation Manual

SIGALARM INSTALLATION AND OPERATION MANUAL / GENERATION 4 WIRELESS / VERSION 4.2
18
3.2 TOOL BAR
(Refer to diagram on page 19)
3.3 SENSOR DASHBOARD
3.4 SET POINT DISPLAY
3.5 SENSOR STATUS GAUGE
Item Top Tool Bar Function
12 GPS Indicates if the Sigalarm system is receiving GPS service
13 GSM Indicates GSM signal strength; Optional
14 Compass Indicates direction
15 AZ/EI Indicates position
1 Menu This icon opens the Actions Screen
Item Sensor Dashboard Function
11 Sensor EID Displays paired sensors
16 Sensor reading This is a numerical representation relative to the voltage
detected
17 Alert status
Indicates the status of the sensor in relation to the setpoint
4 Battery life Indicates battery status for each sensor
Item Sensor Dashboard Function
2 Setpoint The adjustable numerical value at which the operator
gets a danger status. Setpoint values range from 5-120
Item Status Gauge Function
3 Status Gauge This gauge is a visual representation of sensor
readings in relation to the setpoint
SETPOINT DISTANCE CORRELATION
The higher the numerical value of the setpoint the closer you can get to a
power line. Example: A setpoint of 90 will allow an operator to get closer to
a power line than a set point of 20.