Use and Care Manual
Flag Kit Components
• (1) 3’ pole
• (1) 2’ pole
• Adjustable bracket
• Wall mounting screws
(2) Mounting Rings
• 3x5’ Embroidered Nylon Flag
To Mount Flag on Pole:
• Repeat the previous step and slide the 2nd clear plastic
mounting ring up to the bottom of the ag so that it meets
with the lower left grommet of the ag. Insert the tensioning
screw through the grommet while slightly stretching the ag.
Note: Unscrewing the knurled tensioning screw may be
necessary for the rings to pass freely over the pole.
To Assemble Top and Bottom of Pole:
• Unscrew the knurled tensioning screw completely from the
ring. Slide the ring up the pole until it reaches the upper most
part of the pole. Remove the tensioning screw and pass it
through the upper most ag grommet. Re-insert the
tensioning screw into the tensioning ring. Tension should be
no more than rmly nger-tight. The metal hook at the top of
the pole will not be used for this application. See Figures 1-2 and
1-3.
• Line up the threaded mounting section of the poles and
screw together until hand-tight. See gure 1-1.
• Mount bracket to building with wood screws supplied. Screws may be utilized by directly attaching to
building exterior, or plastic inserts may be required when mounting to masonry applications. In the event
of a masonry installation, a mortar bit must be sourced prior to the holes being drilled. Mark holes prior to
drilling, drill with masonry bit, insert plastic inserts, and secure the bracket with the supplied screws.
• Adjust bracket to desired angle and hand-tighten wing nut rmly to secure. Overtightening may damage
the bracket.
• Insert pole into bracket and hand-tighten the set screw to secure the pole.
To Mount Flagpole to Building:
(Figure 1-2)
(Figure 1-3)
(Figure 1-1)
Missing a part of have questions? Our ag kit is backed by a 100% Customer Satisfaction Guarantee.
Give us a call at 1-888-932-3524 or e-mail us at info@usagstore.com
We want you to be completely satised with your purchase!