Installation manual

6. ADSL Profile Configurator or Loader doesn’t detect an ADSL modem in your network
- Check if the modem is in the same physical LAN as the configuring PC
- Check if the modem’s IP address is in the same IP-subnet as the configuring PC.
This IP-address can be found in the downloaded profile using the ADSL Profile
Configurator. If the configured IP-address is not in the same subnet, then use the ADSL
Profile Configurator or Loader from a PC which IP address is configured within the same
subnet as your ADSL modem, or reset the modem to it’s factory default settings (see 4.).
Review the profile (especially the IP-addresses) you’re using before trying to download it
again.
USB
7. USB-led is not burning: Your ADSL modem doesn’t detect a USB host
- Does your PC have USB support installed properly?
8. After installing a PPP ATM dialup-adapter, the system doesn’t add this entry to it’s list of
devices
- This is a known issue when the ADSL modem does not have an active ADSL link to your
provider.
Please check and make sure that the ADSL led is burning before installing the ADSL
modem.
Do not reinstall the drivers but make sure that you have an active ADSL link and reboot
your PC.
9. Can not bind a TCP/IP protocol stack to ATM SVC using an IPoA configuration.
- This is a known issue when the ADSL modem does not have an active ADSL link to your
provider. (See point 8.)
Allied Data Technologies 45
CopperJet 81x
CJT 81x 02-10-2001 11:45 Pagina 45