Installation manual

Configuring IPoA.
1. Select IPoA as profile type and
click on OK.
2. Set the LAN TCP/IP parameters.
(CopperJet 81x IP-Address)
Set the interface type.
USB when the CopperJet 81x is
connected with a USB cable.
Ethernet when the CopperJet 81x
is connected with a Ethernet
cable.
Select the Line modulation. (ADSL connection Protocol)
-Multimode : Modem will detect the Modulation offered by the CO (Preferred)
-T1.413 : ANSI ADSL Standard
-G.Lite : G.992.2
-G.Dmt : G.992.1 Annex A
Set the ATM PVC (Virtual Circuit) parameters.
-VPI : VPI Channel Number
-VCI : VCI Channel Number
-PCR : Peak Cell Rate
Set the WAN TCP/IP parameters. ( CopperJet 81x WAN IP-Address)
Set NAT (Network Address Translation) if needed.
You must set NAT when de LAN IP-Address differs from the WAN IP-Address.
Allied Data Technologies 33
CopperJet 81x
CJT 81x 02-10-2001 11:45 Pagina 33