Installation manual

Configuring RFC1483 Bridged.
1. Select RFC1483 Bridged as profile
type and click on OK.
2. Set the TCP/IP parameters.
Optional: an IP Address and Subnetmask is only needed for further management use.
Select the Line modulation. (ADSL connection Protocol)
-Multimode : Modem will detect
the Modulation
offered by the CO
(Preferred)
-T1.413 : ANSI ADSL Standard
-G.Lite : G.992.2
-G.Dmt : G.992.1 Annex A
Set the ATM PVC (Virtual Circuit)
parameters.
-VPI : VPI Channel Number
-VCI : VCI Channel Number
-PCR : Peak Cell Rate
Select the forwarded Packet types.
-None : This will forward
all packets
-Forward PPP: This will only forward
PPP packets
-Forward IP : This will only forward
IP packets
Select spanning tree if this
is required.
Allied Data Technologies 23
CopperJet 81x
CJT 81x 02-10-2001 11:45 Pagina 23