Installation manual

Chapter 3: Connecting the CopperJet
3 Connecting the CopperJet
To connect the CopperJet to the computer, you must have installed an Ethernet
10/100Base-T card in your computer. You need to have a static IP address on your
network card that is in the same subnet as the web interface IP address of the CopperJet.
The default web interface IP address for Ethernet is 172.19.3.1 (USB IP address is
172.20.3.1). When using the default IP addresses, your network card can have the
following IP address 172.19.3.2 with subnetmask 255.255.0.0.
3.1 Connecting the CopperJet 16xx series
CopperJet 1610 CopperJet 1612
Power ADSL Ethernet
RJ-11 RJ-45
Cross
DSL Provider
Power supply
Computer
Power ADSLUSB Ethernet
RJ-11
RJ-45
Cross
DSL Provider
Power supply
Computer
CopperJet 1614 CopperJet 1624
PWR USB
ADSL ETH
1-2 3-4
ISDN Phone
Computer
RJ-45
Cross
RJ-45
PhonePower supply
DSL Provider
RJ-11
PWR USB
ADSL
1 234
1-2 3-4
ISDN Phone
Ethernet
Power supply Phone
RJ-45
DSL Provider
RJ-11
RJ-45
Straight
Computer
CopperJet 1616 CopperJet 1626
PWR
12
USB
ADSL
Phone
1 234
Ethernet
Power supply
Phone
RJ-11
DSL Provider
RJ-11
RJ-45
Straight
Computer
Power supply
Phone
RJ-11
Computer
Power ADSLPhone 1 EthernetPhone 2
RJ-45
Cross
DSL Provider
RJ-11
Page 7