Installation manual

Chapter 6: WAN Configuration Examples
Page 78
6.3 Configuring a PPPoA connection with NAT
In this section is described how to configure a PPPoA connection (RFC2364 routed).
Follow the steps below to configure the CopperJet for PPPoA.
1- Go to Configuration -> WAN connections.
2- Delete any existing WAN connection by clicking on the Delete… link.
3- Click on Create new Service.
4- Select as WAN Service RFC2364 Routed Service attached to the Router.
5- Fill in the correct VPI and VCI values and Username and Password that is provided
by your ISP.
6- Click on OK.
7- Preferred is to have the DHCP Server of the CopperJet enabled.
8- Save the configuration (Configuration -> Save config and click on Save).
9- Make sure that your network card is configured correctly.
For more advanced settings, go to section
5.6.5 Configuring PPPoA routed service attached
to the Router.
6.4 Configuring a PPPoE connection with NAT
In this section is described how to configure a PPPoE connection (RFC2516 routed).
Follow the steps below to configure the CopperJet for PPPoE.
1- Go to Configuration -> WAN connections.
2- Delete any existing WAN connection by clicking on the Delete… link.
3- Click on Create new Service.
4- Select as WAN Service RFC2516 Routed Service attached to the Router.
5- Fill in the correct VPI and VCI values and Username and Password that is provided
by your ISP.
6- Click on OK.
7- Preferred is to have the DHCP Server of the CopperJet enabled.
8- Save the configuration (Configuration -> Save config and click on Save).
9- Make sure that your network card is configured correctly.
For more advanced settings, go to section
5.6.6 Configuring PPPoE routed service attached
to the Router
.