Installation manual

Chapter 5: Configuring the CopperJet
• G.726 (32kb) and
• G.729 a/b
After the correct settings are filled in, click on Apply. Go to the Configuration menu and
click on Save config to save the new settings into the CopperJet. MGCP is only active after
a restart of the CopperJet. To Restart the CopperJet, go to System -> Restart and click on
the Restart button.
5.18.2.1 Configuring Call agents
To configure Call agents, click on the Edit Call Agents link. Then click on the Create new
VoIP Call Agent link. The Create VoIP Call Agent page is displayed.
You need to add detailed configuration information about the MGCP service that you are
creating. This information must be provided by your service provider.
Domain: A domain name (eg. callagent.test.net) or an IPv4 address
(eg. 192.168.1.1).
Port: The MGCP port. Default the port number is 2727.
After configuring the fields, click on OK. Go to the Configuration menu and click on Save
config to save the new settings into the CopperJet. MGCP is only active after a restart of
the CopperJet. To Restart the CopperJet, go to System -> Restart and click on the Restart
button.
5.18.2.2 Advanced MGCP Configuration
Configuration of advanced Voice over IP settings in the CopperJet IAD’s is done through
TELNET. To access the TELNET configuration mode, start a TELNET session from your
computer (i.e. TELNET <ip-address>) and enter your username and password (default
username and password are admin, admin). To see the VoIP settings type the following
command:
-->voip show <Enter>
With this command you see the SIP and MGCP settings.
To see the options available for MGCP, type the following:
-->voip set mgcp ? <Enter>
Page 73