Installation manual

Chapter 5: Configuring the CopperJet
-->voip set sip outboundservertransport udp <Enter>
5.18.1.13 Enable SIP tracing in the CopperJet
To enable SIP tracing in the CopperJet, please follow these steps:
• Open a telnet session to the CopperJet
Note: To open a telnet session, go to Start -> Run and type cmd and click on
OK. A DOS box will open. Now type telnet 172.19.3.1 and press Enter.
Default username and password is admin.
• Type the following commands:
-->system log enable voip pots <Enter>
Note: VoIP must be registered for using this command.
-->console enable
Quantum>log level 1 <Enter>
The trace is now started.
To stop the logging, type:
Quantum>log level 0 <Enter>
Page 71