Installation manual

Chapter 5: Configuring the CopperJet
-->voip set sip proxyroute strict <Enter>
5.18.1.8 Configuring Registration Expires
This command specifies the time interval after which registration with the SIP Proxy Server
is refreshed. The Voice-IAD systems will automatically attempt to refresh their
registrations before they expire. If they expire without being refreshed then the SIP
Registrar deletes the corresponding entries and the phones connected to that Voice-IAD
system will no longer be able to receive incoming calls as it will be unknown to the
Registration Server.
-->voip set sip regexpires <seconds> <Enter>
Example:
-->voip set sip regexpires 3600 <Enter>
5.18.1.9 Configuring Registration port
This command is used to identify the port used by SIP agents to communicate with the SIP
Proxy server.
-->voip set sip regport <port> <Enter>
Example:
-->voip set sip regport udp <Enter>
5.18.1.10 Configuring Outboundserver
This command sets the outbound server address.
-->voip set sip outboundserver <address> <Enter>
Example:
-->voip set sip outboundserver sip.example.com <Enter>
5.18.1.11 Configuring Outboundserverport
This command sets the outbound server port.
-->voip set sip outboundserverport <portno> <Enter>
Example:
-->voip set sip outboundserverport 5060 <Enter>
5.18.1.12 Configuring Outboundservertransport
This command sets the outbound server transport.
-->voip set sip outboundservertransport {tcp|udp} <Enter>
Example:
Page 70