Installation manual

Chapter 5: Configuring the CopperJet
5.17 Configuring Voice over DSL
Basic configuration of the Voice over DSL (VoDSL) settings in the CopperJet Integrated
Access Device (IAD) can be done through the WebServer Interface. Advanced
configuration can only be done through TELNET.
5.17.1 Basic VoDSL Settings
To configure the basic Voice over DSL settings, go to Configuration menu and click on
VoDSL. The VoDSL page is displayed.
You need to add configuration information for VoDSL. This information must be provided
by your Voice over DSL service provider.
VPI: Virtual Path Identifier. A field in the ATM header. The VPI is
used to identify the virtual path that a circuit belongs to.
The VPI can be any value between 0 and 4095.
VCI: Virtual Channel Identifier. Part of the ATM header. The VCI
is a tag that identifies which channel a cell will travel over.
The VCI can be a value between 1 and 65535.
Coder Law: ALAW is in general meant for Europe.
ULAW is in general meant for the US.
None: There is no VoDSL signaling configured.
CopperCom: CopperCom proprietary VoDSL signaling.
Paradyne/Jetstream: Paradyne/Jetstream proprietary VoDSL signaling.
BLES: BLES VoDSL signaling.
ELCP: ELCP is a standard protocol that specifies the mechanism
where V5.2-based signaling messages are exchanged
between the VoDSL Gateway and IAD to support both
POTS (plain old telephone system) and ISDN voice over
ATM.
Page 60